and then turn on the Transmitter ? That could cause this. You did not happen to keep the old 1.8 file on the machine ( Sd card ) did you. Get a RMA number, the turnaround times have been pretty quick. Tell DJI that you have this failure, they will know what you are talking about. I had seen this plenty of times so I wrote the tutorial on hidden files, when lines 08 say 'Device not Detected ' the video module is either corrupted or failed. From what I have been told if it is not warrenty cost is between 50 to 100 US dollars. I am pretty good at this, ( Not my first Rodeo ) I can tell you with complete certainty that it must be repaired by DJI techs. This can happen for a variety of reasons, the most common is updating the aircraft and having the Somehow the Video Transmission module is Corrupted it MUST go in for service to be repaired Shutter, I am just going to bottom line you. Yeah I'm working on that, my girlfriend is in New York. Yes, I did both the reset and the relinking. But like I said, I had NO ISSUES before 2.8.2 GO.Īnd to tpetersen97: I don't have any videofeed at all, it's completely dead. This is a mystery to me.Įverytime I talk to someone from DJI, they seem to think that it was a firmware upgrade on the RC or the aircraft that caused this. Most people seem to have their phantoms fly just fine again after installing 2.8.3. What I don't understand is how DJI GO 2.8.2 could trigger this in my aircraft and make it so bad that I have to send it in. Packet upgrade failed at version checking.

My hidden log says 'Device not detected' on both module 8 and 15. Oh, and I also got the 'firmware update' beeping noise on the aircraft at the same time as the 'no signal', even though I already had the latest firmware installed since it came out without any problems at all. Later that night I was going out for a flight and boom, 'No signal'. What happened was that my phone installed the 2.8.2 update for GO on my phone by itself when I was on my wi-fi. I have been flying with the 1.8.80 update on the aircraft and the latest rc update without any issues since the day they came out. So this issue occurred after the 2.8.2 GO update. Shutter, If you would like, re load the latest update to the aircraft (1.8 if this is the latest.

Carvewright update firmware on machine